Registration for Boiler, Steam Generator, Process Heater

Effective January 1, 2011, Regulation 9, Rule 7 requires certain boilers, steam generators and process heaters to be registered with the District and comply with the emission limits set forth in the rule.

To determine if your boiler is subject to this rule please address the following applicability requirements:

Exemption Requirements:

  • the rated heat input is less than 1 MM Btu/hr (30 Boiler horsepower) or
  • the rated heat input is less than or equal to 2 MM Btu/hr (60 Boiler horsepower) and the boiler is fired using only natural gas or LPG

If either of the above apply you are exempt. No further action is required.

Registration Requirements:

  • the rated heat input is greater than 2 MM Btu/hr and less than 10 MM Btu/hr
  • the boiler is fired using only natural gas or LPG
  • the boiler is not located at a petroleum refinery
  • the boiler is not used to generate electricity

If all of the above apply your boiler is required to be registered.
Please complete the Boiler Registration form.

For more information, see the Regulation 9-7 Compliance Advisory.

Fees

The registration fees are set forth in Regulation 3, Schedule R. Both the initial registration fee and the annual fee are for each registered equipment. Late registrations and late payment penalties may apply.

Renewal

Depending on the permit or registration expiration date for your facility, you will receive renewal notices accordingly on an annual basis. Renewal invoices are typically sent out 30 to 60 days before expiration.

Contact Us

Asbestos, Compliance & Enforcement

415.749.4762 asbestosjobs@baaqmd.gov

Compliance & Enforcement
Underground Tanks

415 749.4999

Online Permitting System Help Desk, Engineering

415.749.8665 PermitHelp@BAAQMD.gov

Grants Programs Information Request Line, Strategic Incentives

415.749.4994 grants@baaqmd.gov

Engineering
General Engineering Information

415.749.4990 permits@baaqmd.gov

Contact Us

Spare the Air Status

Last Updated: 6/21/2021